At the moment I am building the 3D Botmaker qualification track (see: https://www.redlinederby.com/topic/building-the-official-3dbotmaker-test-track/3249 ) but then as a one-lane mirrored track. Since that is what I can build with the components I could get quickly. It will be as close of an approximation as I can manage, since I also don't have the Sizzlers track curves, so I am using these for the 180s curves: https://play.hotwheels.com/en-us/shop/productdetail?id=10001137&ProductName=Hot-Wheels-Track-Builder-Track-Essentials-Curve-Pack&Category=toytype&SubCategory=Accessories&SeoName=accessories .
The only trouble is: where is the finish on that track (exact measurements) ? I cannot see that on that forum either. The drawings show a 2" x 3" lumber part that makes the End Runoff, is it maybe exactly at the end of the End Runoff then?
Asking this because hope to finish my one-lane track of this tomorrow. And want to start testing and taking down times at the start of next week, maybe even earlier. Just hoping the Sprinttimer app on my iPhone is up to the task of taking good photo finish shots, used it before for my MiniRC.